Need help - peugeot 308 ecu swap

[NIGHTCD]

Hello.

hope there is someone that can help.
my Brother has an Peugeot 308 sw that have been crashed, and the ecu in the engine compatment is broken to peices.

the ecu has been changed from another car..
and now the car does not start.

we have Access to Peugeot planet, but need some advice to what we need to change and where to go..

if we must reprogram the imobiliser we need some key? (where to get that key)

hope there is someone that can help..

kind regards
NIGHTCD

[Larue]

You need new/used Engine control unit. If it's new then you need immobilizer code from dealer or from this thread: http://www.digital-kaos.co.uk/forums/f178/psa-vin-pin-286776/
and program it with PP2000/Diagbox.
If it's used then you need somebody who can virginize/set to new state ECU,then program it with PP2000/Diagbox.

[NIGHTCD]

You need new/used Engine control unit. If it's new then you need immobilizer code from dealer or from this thread: http://www.digital-kaos.co.uk/forums/f178/psa-vin-pin-286776/
and program it with PP2000/Diagbox.
If it's used then you need somebody who can virginize/set to new state ECU,then program it with PP2000/Diagbox.

hello.

thanks for the reply..
can i use the "used ecu" and then use pp2000 to change VIN on the other components and then make it run?
or do i have to get the used ecu virginize?

can i virginize the ecu self?

[Larue]

Before fitting used ECU you need reset immobilizer(set it to "new" state) and then program and change configurations to your car with PP2000 . Without immobilizer reset you can not program it with PP2000.
You can virginize ECU by yourself only if you have programming skills and tools to read chips inside ECU....previous experience in that kind of work is greatly appreciated .:laugh:
Have look in "IMMO" section and you will understand what I'm talking about.

[NIGHTCD]

Before fitting used ECU you need reset immobilizer(set it to "new" state) and then program and change configurations to your car with PP2000 . Without immobilizer reset you can not program it with PP2000.
You can virginize ECU by yourself only if you have programming skills and tools to read chips inside ECU....previous experience in that kind of work is greatly appreciated .:laugh:
Have look in "IMMO" section and you will understand what I'm talking about.

and then i can use the original bsi and keys?
i have talked to another people and they says that i need all the parts from the same car.. ecu, bsi, keys etc. to get it to work,

maybe if i can get to read the chip i can get someone to virginize it for me?

[Larue]

If you have virgin(new) ECU there is no need for any other parts and that is right idea to search for somebody who can virginize second hand ECU. If you haven't done this kind of job then this isn't right way from were to start learning programming.
Cheers
Larue