hybrid corsab m1.5.5

[gccb]

hi,
i m trying to fit a second hand ecu on a corsa b 1.0 12v with bosch m1.5.5 , what is the easiest method to adapt ecu?
regards.

[gttuning]

i think u have to have virgin ecu to coded to car.not sure.

[pablo1971]

YES-gttuning is correct-you need sercurity car pass for the ecu.and you use this to progrma ecu to car....opcom or tech2 can do this.

[gttuning]

i check few notes there is eeprom 24c02 copy this to your second hand ecu,that should work,but not sure again.post result please. there is immo of solution for this if u need read this eeprom 24c02.but try copy first.

[gccb]

how to read such decice?

[gttuning]

how to read such decice?

x-prog or some other programer.but try to solder out eeprom and solder in to second hand ecu .make sure solder the way it was not upside down (very important)

[gccb]

is it possible to disolder eeprom o,n hybrid ecu?

[gttuning]

dont know never at this job yet.

[gccb]

SO who already had some experience with this unit?

[easytech]

Had same problem some weeks ago.
carprog should read eeprom by k-line but had no luck.
Easiest way is to find complete set ecu, immobox and
keys on the scrapyard

[gccb]

can somebody here generate pin from vin, so i can reset ecu and match it with car?

[immokill]

use opcom mate and activate immo in second hand ecu .

[gccb]

so i do not need pin from second ecu if i use opcom??

[gccb]

any idea???????

[pablo1971]

you need the pin from 2nd hand ecu....with the pin you can program ecu to car---immob etc.

[elephantul]

not need pin, only put second hand ecu in car, use opcom- securiti acces, wait 5 min, job done

[gccb]

i will try and report

[immokill]

No need pin ,put ecu and go in engine and activate immobiliser .

[youssef70]

hello
possible also with AD100 T300 Tcode or MVP