View Full Version : Polo 1.4 16 V engine type BBY Ecu MM IAW4MW opinion about MOD map
djdanielb
27th July, 2010, 12:00 PM
Someone could tell me his opionin about the MOD map of this car ?
Is there a solution to close EGR valve ?
Someone could close it ?
Is it possible to improve this map ? where ? Is it a good map for a GPL engine ?
Is there a better map than this ?
Tank you so much
oldford
27th July, 2010, 07:45 PM
How much bhp did you gain on the rolling road?
What's the CO-level (before the cat) or the lambda number with WOT?
djdanielb
28th July, 2010, 10:19 AM
I never tryed on rolling road. The mod map is better than original but I don't know if this map il the best.
How can I read the CO value from oxygen sensor ? By vag com ? wich address ?
Could you improve this map ?
Could you close EGR valve by map ? by vag ?
thank you so much
oldford
28th July, 2010, 10:25 AM
If you didn't use a rolling road and didn't measure the CO percentage, the odds are this map produces less power than the original one and could damage the engine.
And if I could make the map better? Assuming it is possible starting from an original map, only on a rolling road and with at least CO measurement. But I doubt there are big gains here. Maybe, if you are very lucky 2 or 3 bhp.
djdanielb
28th July, 2010, 10:42 AM
Thank you for your answer.
I know that with this engine the gain is low, I asked this becouse I hoped that you (or someone) made this tuned car before, and now could give me some opinion.
BR
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.