corsa c dashboard swap can i swap 8 pin from old clocks to donor clocks..??

[aidyk]

hi
usual story with corsa c clocks, plug loose and some clown superglued it in, so guy got new clocks and fitted but no start, phoned me and i told him immo is in clocks needs programmed.
can i swap 8 pin chip from old clocks to the new ones..?
i have op-com but must be bad sw wont erase codes or programme anything.!!
car is 1.2 and year 2002..

regards

[lupu_sandu]

Corsa C have Nec MCU in dash.
Use op-com, read security code from dash, then enter programming>resset dash.
Car will start now.

[aidyk]

Corsa C have Nec MCU in dash.
Use op-com, read security code from dash, then enter programming>resset dash.
Car will start now.
hi
read security code from old clocks.? old clocks are scrap plug stuck in socket so new plug soldered onto car harness.
but i have security card for replacement clocks. all numbers etc.
do i just need to reprogramme.?

[lupu_sandu]

If you have car pass from donor car is OK.
Go to Programming>Reset IPC>Security Code>OK
Start the car.
At this point you have error on dash: PIN not programmed.
If you have old PIN Code you can program IPC back to car.

[sparkle]

hi guys

i want to swap clocks on this model aswell . i dont have op-com . i can read eprom data from original with diga . can i edit security code from original to donor dash ? where is this code stored ? or is it easier to swap micro .......


regards
sparkle

[lupu_sandu]

If you can , swap NEC MCU from dash.

[aidyk]

my opcom isnt good sw version so i sent owner to opel service, recoded all ok thanks