View Full Version : ews 3 pin out
javilette
25th January, 2011, 09:50 AM
i have one bmw e 36 320 d 136cv i bought a emulador for immo but i dont khnow the pin out.
i think that:
pin 10 +
pin 13 k line
pin 9 ground
and what wires i have to brigge for the starter works??
regars
lupu_sandu
25th January, 2011, 09:55 AM
Hope this will help:
cjawahir
25th January, 2011, 10:08 AM
i have one bmw e 36 320 d 136cv i bought a emulador for immo but i dont khnow the pin out.
i think that:
pin 10 +
pin 13 k line
pin 9 ground
and what wires i have to brigge for the starter works??
regars
hi , before you connect k line to pin 13 you have to write isn code to emulator .
you need to read the isn number from your ews module , then write it to emulator ,
you need to set jumper on emulator and connect to pin 4 on ews3 , then write to emulator , after remove jumper connect to pin 13 , then connect starter wire pin 1 and 2 on ews3 together .
cj
javilette
25th January, 2011, 10:48 AM
ok i have the software for ins and can i see the ins in ews whitc x prog??
and for write ins in emulador what interface i need for this?
the sofware for write ins i see that it works by serial port.
cjawahir
25th January, 2011, 11:00 AM
ok i have the software for ins and can i see the ins in ews whitc x prog??
and for write ins in emulador what interface i need for this?
the sofware for write ins i see that it works by serial port.
use inpa to read isn pw , and then use emulator software to write it , with same interface k line .
cj
javilette
26th January, 2011, 10:51 AM
the software for emulador have for com1 serial port can is used this software whith inpa usb interface????
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.