immo off siemens ems 3134 renault clio

[powered by]

Hello! I need help. I have a ecu siemens ems 3134 need immo off. Thanks.
king regards

[albertros]

Hi,
Can't be done. 182?

Better post problem.

[powered by]

I'm sorry I do not understand. thanks

[magnacin]

Attached is a working immo off ECU (tested). Remember, key and imobilizer should be "brothers" in order for this to work. Otherwise vehicle won't start.

[crx1616]

Attached is a working immo off ECU (tested). Remember, key and imobilizer should be "brothers" in order for this to work. Otherwise vehicle won't start.
what do you mean my brothers the key and immo must be coded to each other !!! any one know s if this file works !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! i need it to bench test ecu not for car

[magnacin]

File works 100%
What I mean is that immo box in kangoo and chip in key must be matched to each other. (At least in MX they must) in order to vehicle to start.
File attached can be used if you lost your ECU, or replaced with a different one but you still keep key and immo box.

[crx1616]

thank s i understand now :manuscarf:

[GolfmkI]

Hello......

What happens finally????

I have now a problem with a Clio sometimes curious UCH, almost every times that uses it recognises key and car starts.

Sometimes Key is not recognized and ligth keep blinking.....so car dont start.........


You are saying that key and uch must be matched?????? So what kind of inmo off it is....?????

I need please someones xplain..THANKS

[didi_du_93000]

Hello......

What happens finally????

I have now a problem with a Clio sometimes curious UCH, almost every times that uses it recognises key and car starts.

Sometimes Key is not recognized and ligth keep blinking.....so car dont start.........


You are saying that key and uch must be matched?????? So what kind of inmo off it is....?????

I need please someones xplain..THANKS

Hello, I have same problem as your.

Have you found a solution?
I have changed UCH with a new one and same problem,

Sometime car start and someone cars don't start and immo led on.

[PierreTheron]

Hello, I have same problem as your.

Have you found a solution?
I have changed UCH with a new one and same problem,

Sometime car start and someone cars don't start and immo led on.

Consider your fault to maybe be in ecu..
When car not start remove plug P201 and refit . See if car starts then.
:adore:

[didi_du_93000]

Consider your fault to maybe be in ecu..
When car not start remove plug P201 and refit . See if car starts then.
:adore:

You thinks if i remove the IMMO i always have same error?

[albertros]

Hi,
there is no immo off solution only rolling code re-set.

Your fault is going to be the key, run a soldering iron over the chip, if no good make a new key.

Removing and refitting P201 resets the ring decoder faultwhich sometimes stops the car from starting.

[didi_du_93000]

But when i make diagnostic with CLIP, and when the car don't start i have in actual values:

Key present: YES
IMMO: ACTIVE


So I think it's not a problem of coil or connector P201.

[albertros]

But when i make diagnostic with CLIP, and when the car don't start i have in actual values:

Key present: YES
IMMO: ACTIVE


So I think it's not a problem of coil or connector P201.
Clip is saying that the key is not being read.

[didi_du_93000]

I will try to learn a new key tonight and report result.

[daviee]

Someone can uploa this file again please, because file is corrupt. Thank you.