audiomeca
25th July, 2011, 03:40 PM
Hello
I brought a xprog-m clone from china with software 5.0. I try to read the eprom from a Smart fortwo 2005 BSI.(9s12DG256 mask 2k79x) I solder the four wires to procesor board, ( I use MY04 connetion layout) I solder pin for BKGD,RESET ,+5V and GND, raise the pin in the upper chip.
only read corrupt data, the security is baypassed, read the memory but not real data.
I have set the usb to serial port with diferent timing, and not good read data.
I try to program normal 8pin 24c02 and read and write all times ok
any ideas? the MY04 circuit layout is correct?
thanks to all .
I brought a xprog-m clone from china with software 5.0. I try to read the eprom from a Smart fortwo 2005 BSI.(9s12DG256 mask 2k79x) I solder the four wires to procesor board, ( I use MY04 connetion layout) I solder pin for BKGD,RESET ,+5V and GND, raise the pin in the upper chip.
only read corrupt data, the security is baypassed, read the memory but not real data.
I have set the usb to serial port with diferent timing, and not good read data.
I try to program normal 8pin 24c02 and read and write all times ok
any ideas? the MY04 circuit layout is correct?
thanks to all .