mitsubishi lancer immo

[KILL_THE_IMMO]

hi all
i have a mitsubishi lancer december 2003 that all keys are losts
when i program it with SBB it write me no loaded key repeat procedure (just one time i dont know why it accepted to programm a new chip and the number of key programmed change from 2 to 1)
when i use x431 to diagnose it write me tp reader not found
plzzzz what does it mean?????????

is this the immobox?? so i dont find any eprom 24C01


thanks:giveup:

[Crash-100]

Foto very bad if you key ID46 you need prepare chip

[KILL_THE_IMMO]

IT IS A 4D61

[workdamnyou]

It looks like a transponder problem. 4C for older model or ID61 for newer model. Could be either. They didn't start using 46's till 05/06.

[KILL_THE_IMMO]

I HAVE PASSED TO PROGRAM ONE CHIP 4D61 WITH SBB BUT CAR DONT START AND WHEN I REPEAT PROGRAM PROCEDURE WITH SBB IT WRITE ME NO LOADED KEY REPEAT PROCEDURE
AND X431 SHOW ME THIS FAULT TP READER NOT FOUND

[keygargoil]

what chip are you reading if its 4c its xisor 24c01 under the dash drivers side, if its id61 then its 4d61 it is either in a small box under the steering rack or behind plastic on a frame to the side of acc pedal if its id46 then its in the aerial 24c01 check the attatched pics you will need a generated mitsubushi chip for programming you cannot just use a t14 zed bull can produce these chips

[magdyman]

Hello keygargoil (http://www.digital-kaos.co.uk/forums/members/162748-keygargoil/)
thanks for this file good job
Regards

[keysph]

Do you have a ignition coil tester? TP reader I think it means ignition coil in their point of view.
To that year the corresponding chip is 4d61. What pincode is used in programing?
No key loaded appears when the chip is not good or cannot be read.
So:
- check the ignition coil
- check the transponder type
- check the transponder position in key