BMW E60 2008 CAS3 9S12XDP512

[258]

I need Eeprom + Flash from Cas 3 61.35-9147217-01
FSV 2.3.8
OSV 3.3.0
HW C4
SW 18.6
index 06A0
inside 9S12XDP512.
This is my eeprom and flash of CAS3, I have tried to read with XProgM, first time has stoop still in "bypass secured", then have installed CAS and DASH in the car and dash is not functioning, only remoter key work.Second time, has XprogM read eeprom and flash, can you check this?

[depredator]

Your dump is good 1 Pcf 7936 Key , 2 pcf 7953 remotekey and 868 Mhz

[258]

Why car does not start, no ignition? although dump is good.

[MV auto]

problem might be internal to CAS. did you mess anything up inside? weld/short something? if terminal 15 is not switching, I would suggest to transfer dump in a diferent unit. I have seen once a similar case. terminal R switch ok but no terminal 15 and/or 50 (run/start). the diagnose point at the CAS unit, but my customer (which is a garage) "state" that after a week let alone, the vehicle start to work back... didn't believe is story, but hey, if you are in no hurry, you might give it a try! HAHAHA
if not, I would try a unit from scrapyard with your dump.

keep us inform!

[258]

problem might be internal to CAS. did you mess anything up inside? weld/short something? if terminal 15 is not switching, I would suggest to transfer dump in a diferent unit. I have seen once a similar case. terminal R switch ok but no terminal 15 and/or 50 (run/start). the diagnose point at the CAS unit, but my customer (which is a garage) "state" that after a week let alone, the vehicle start to work back... didn't believe is story, but hey, if you are in no hurry, you might give it a try! HAHAHA
if not, I would try a unit from scrapyard with your dump.

keep us inform!

ok i try it. Thanks for help

[elephantul]

maybe when pull out cas, wire from ignition swich in cas is broken

[258]

I again tried to install car CAS module and does not work. Then I wrote on it old eeprom and it works.I think that, when being read out went wrong. And then the second time all read well.

[mrecovery]

do you have this files?

[mrecovery]

I need Eeprom + Flash from Cas 3 61.35-9147217-01
FSV 2.3.8
OSV 3.3.0
HW C4
SW 18.6
index 06A0
inside 9S12XDP512.
This is my eeprom and flash of CAS3, I have tried to read with XProgM, first time has stoop still in "bypass secured", then have installed CAS and DASH in the car and dash is not functioning, only remoter key work.Second time, has XprogM read eeprom and flash, can you check this?
can you send me your origiginal files ? for some reason i cannot download them. my email is xxxxxxxxxxxxxxxx