HELP-How repair OPCOM after update "OP-COM Prof 131223c EN"

[lkjubaking]

How repair old OPCOM v2 after update "OP-COM Prof 131223c EN"

I tried this
Repair Op-com Hardware Procedure?
http://www.digital-kaos.co.uk/forums/f152/repair-op-com-hardware-procedure-156380/?highlight=opcom+repair

I tried this with an external programer and all possible firmware but Opcomfut says firware 7F.0

[lkjubaking]

Nobody for help?

[MJRVR]

Yes buy a new one. So cheap now not worth trying to sort.

[mexanico1971]

Hi !
I think in this way you don"t get there !
use a PIC programer like old williem PCB and reflash the PIC !
At the moment I dont have the dump on this PC, but If some one have it on hand !
the pic I have

Good luck

[stas12]

here is the dump for pic.

[lkjubaking]

Thanks for your help but I already tried and not work,says firware 7F.0

[apv]

Download from here Mprog - Download (http://www.filecrop.com/search.php?w=mprog&ize_i=0&size_f=100000000&engine_r=1&engine_d=1&engine_e=1&engine_4=1&engine_m=1&engine_t=1)
Download from hereDepositFiles (http://dfiles.eu/files/nins0r4es)
Connect the device to the computer. And create an open mprog Export Team with ept file. After creating the template click on schedule. D Make sure the correct driver installation.

[lkjubaking]

Thanks friend
but how it works?

[apv]

?Qu? preguntas tiene usted?

[speedy100]

Hi !
I think in this way you don"t get there !
use a PIC programer like old williem PCB and reflash the PIC !
At the moment I dont have the dump on this PC, but If some one have it on hand !
the pic I have

Good luck

Hi,
I have been playing all day trying to repair my OpCom.
I have found the hex file etc. and I am using Willem ver. 5.0 programmer in serial mode.
It reads, erases, writes code but does not write Data!
Do I need to lift any pin of the board? or any other idea?

Thank You for Your time!
B.R

[jobalz85]

I've got the same problems :-( But thanks for all the support so far! Many of the info came handy :-)