PDA

View Full Version : Chrysler VOYAGER 2.4L 16v 1998 immo off



skens
11th March, 2014, 04:59 PM
hi
i need immo off solution
ecu S/N T69EH2738B6345 2 gray connectors 95040 st
immo box 5WK4 788B
i try remove eeprom,immo box
thx

lupu_sandu
11th March, 2014, 05:10 PM
Test this file off. Keep immobox removed. Pass in pm.

kazikk
11th March, 2014, 05:12 PM
try this file - disconnect immo box

skens
12th March, 2014, 10:26 AM
hi

thank you both,

the same dump you sent me! relays rejoices as and when there is no eeprom! cars not start!

any idea?

thx

skens
12th March, 2014, 10:27 AM
hi
thank you both,
the same dump you sent me! relays rejoices as and when there is no eeprom! cars not start!
any idea?
thx

elephantul
12th March, 2014, 04:56 PM
skens, trust my, today i have same trouble with same car, chrysler voyager, gasoline, with skim, i make immo off in ecu in 95040, (i make with same methode in 2 sebring and work ok), disconect skim, shunt starter relay, but car not start, i see you thread and waiting your results, my car is not im my garage, is in another garage, i told car owner to bring car in my garage, tomorow morning i have car in my garage and make more test and try, i comunicate any results,

elephantul
13th March, 2014, 08:07 AM
try and put this,solder good eprom, disconect immobox, shunt starter relay

skens
13th March, 2014, 11:44 AM
hi
i try ,but not accepts !!
heard that the pump works! shunt relay!start, but accepts no!!

any solution
regards

datapage
13th March, 2014, 12:08 PM
hey mate.
Car starts and stops? = Can decode.
Car does not start or you have to = electronics electrical problems. review.
Decode simple FFFFFFFFFFFFF=ok, diconect immobox

skens
13th March, 2014, 12:10 PM
hi
this dump ,start.bin!
Auto accept and runs 5 seconds and then turns off and so 3x, then do not start!
dump after 3x not start
regards

skens
13th March, 2014, 12:15 PM
hey mate.
Car starts and stops? = Can decode.
Car does not start or you have to = electronics electrical problems. review.
Decode simple FFFFFFFFFFFFF=ok, diconect immobox



hi
yes Car starts and stops!
send me can decode solution!
regards
thx

skens
13th March, 2014, 04:00 PM
hi
i put all FFFFFFF
Car starts and stops!3x
any decode solution??????????????????????
regards
thx

elephantul
14th March, 2014, 12:50 PM
i manage to start car , but not with immo off, i clean good plug from bcm and skim, about experience with immo off, i think after make vin and synk bit with skim FFFF in engine ecu, is not enough to disconect immobox, think must cut conections from ecu to bcm,

skens
14th March, 2014, 01:19 PM
hi
where the BCM and skim?



What is it "skim"?


send a picture
thx

elephantul
14th March, 2014, 02:23 PM
skim is small ecu from you picture, bcm is on driver footwell, i give car to customer, dont have picture

skens
14th March, 2014, 05:14 PM
Hi
Where is alarm!location?
Regards


Sent from my iPhone

skens
15th March, 2014, 12:18 PM
hi
Where is the location of the alarm? Not on the roof!
regards

datapage
15th March, 2014, 01:04 PM
plug nozzle simulator, it runs 5 minutes.
check signal gun again, call one by one without engine off.
Logged Out immo box.
if not use alarm con

skens
17th March, 2014, 11:51 AM
hi
i put all FFFFFFF
led SET ALARM lights steadily
Car starts and stops!3x
and SET ALARM flashes
no start!
Where is the location of the alarm? Not on the roof!
regards

skens
18th March, 2014, 01:33 PM
hi
new moment i faud a module inside E75J
MC68HC11K4
any idea??
thx

dreniqereti
1st November, 2014, 12:03 AM
Hello Dk. If I send you org dump of voyager can you make off immo pleas I need help obout chrysler voyager 2.4L 16V 1999

luizdoval
1st November, 2014, 03:30 AM
pass please

miguel974
6th March, 2016, 07:40 PM
Test this file off. Keep immobox removed. Pass in pm.
is it possible you have the password

MANI1982
15th July, 2016, 07:19 PM
hi.
I have a chrysler 2.4 a?o1998 to make immo off p / n 0472 p04727231AJ MODULE S / N T54EH1408A5832