Aygo problem immo sync

[eiemax]

Hello friends, I have a problem with a Toyota aygo 1000cc. My problem (without a reason) is that the car start, and immediately turns off. I think that is a problem of keys, or sync ECU.

Tha data of the 2 key, read with zed-bull, is: Type 4D crypto WR

1) pg1: 33
pg2: F0
pg3: FFBE110B
pg4: 0000000000

2) pg1: 53
pg2: F0
pg3: 0912E10C
pg4: 0000000000

Attached are the file from immo and ECU bosch
I ask, if is possible verfy where is the problem in my file of the immo system

Can someone help me with my problem?

Thanks in advance friends

[doaa]

hello
then synchronize ecu connected in dlc 4 - 13 for 35 min
good luck

[eiemax]

Is possible verify if the file and key sync are correct? Thanks

[deondti]

eiemax , I hear you....
My approach would be to virgin the Immo ,
the keys auto code with a procedure
Sync immo - ecu manually

[gwee]

keys in dump, ecu/immo sync code ok

check wiring

[deondti]

Our everyday toyota hero gwee comes to the rescue once again. Thanks gwee

[yusef]

Check fuses for immo & engine management , located around instrument panel. Also blocked cat will be similar symptoms

[eiemax]

Hi friends, very thanks at all... can you tell me which wires to check?

Thanks in advance

[PierreTheron]

Check spark and injector pulse ..
Do you need a tested file set to test on this car m8?

Seems these vehicles sometime get corrupted .

You will just need to to make a transponder on TPX2 with zedbull clone .. with my file set solution.

Regards

[eiemax]

Ok friend, you can post your file?

[PierreTheron]

Have sent you file set m8

[eiemax]

yes friend very thanks. i test and report