PDA

View Full Version : toyota prado


aslamaslam
5th October, 2015, 07:22 PM
hi to all
toyota prado 2000 diesel
lost all key
i try to add new key . the immo light is off now but car is only cranking, not starting
334361
are the read correct withe 8 byte or 16 byte?
can any help for this post please
hani key
5th October, 2015, 07:23 PM
Old 4c !!

Sent from my LG-D855 using Tapatalk
aslamaslam
5th October, 2015, 07:28 PM
yes 4c
the immo light is off now but car is only cranking, not starting
aketokediag
6th October, 2015, 09:43 AM
yes 4c
the immo light is off now but car is only cranking, not starting

Hello M8,
Try and perform syncronize between the ECU and IMMO open driver's door, turn ignition ON short terminals Tc (PIN13) CG(PIN5)in the DLC/OBDII connector leave it for 45minutes the car should start :):)
aslamaslam
6th October, 2015, 01:22 PM
I have only old 22 pin diagnotize plug in the motor hood
darrenhyland
9th November, 2015, 02:24 PM
did you sort this????? I have the same problem
aslamaslam
9th November, 2015, 05:59 PM
hi
please contact achaacha
fadhle
9th November, 2015, 06:41 PM
Ok mate select 93lc66B in your programmer and load this dump,
Mount immo box to car then insert three 4c keys one by one,
lastly security will off, then start your car, regards.
yanivh
25th March, 2016, 02:53 AM
Hi,
I am trying to read the chip 93lc66B from the same car and model.
But my minipro can't read it off the car.

Any suggestion for good reader ?

what im using:
https://www.youtube.com/watch?v=FLG03f_ua5g
aketokediag
27th March, 2016, 12:01 AM
Hello M8,make use of your X PROG M it will read it successfully.
Regards