TOYOTA AVENSIS 1998 LOST KEY

[strikeforce2]

please how can I read HC05E6 with xprog 5.5.1 clone. I desolder and put it on sop28 adapter but always getting an error "device silent, timeout error". If it can not be read please I need immo off.

[rokibar]

put oscilator 2mhz at pins 3 and 4 will read tham

[strikeforce2]

please what chip do I read on the ecu to virginise. there is a 93c56 on the ecu labelled IC 530 but not sure if it the one.

[strikeforce2]

put oscilator 2mhz at pins 3 and 4 will read tham

please do I put the oscilator when reading on the board as in picture or when reading incircuit and can 4mhz oscilator work because I do not have 2 mhz. thanks again

[ayhanozdemir1982]

Hello Do you have another eeprom reader like MTRK or Orange 5
This MCu has security so I think Mtrk ,Zed-Prog,or a device like that can be read easly

[strikeforce2]

Hello Do you have another eeprom reader like MTRK or Orange 5
This MCu has security so I think Mtrk ,Zed-Prog,or a device like that can be read easly

I only have xprog clone. thanks anyway

[rokibar]

like you put wires at programming board have to put oscilator at pins 3 and 4. oscilator must be 2mhz.

[rokibar]

393666 as at picture