2006 Ford E-150 Cluster repair or mileage correction

[borshch]

Hi friends, I got here 2006 Ford Van E-150,
the dash cluster sometimes stops working and radio and power windows dont work then,
so this problem i heard is very hard to fix and best is to replace the cluster,
so we got a replacement cluster but not need to mileage correction on it,


whats the easiest way to do Mileage Reprogramming on this cluster ?
what chip eeprom or mcu does it have ?


but if its possible to repair the original cluster I'd rather repair the original cluster.

[epd1221]

Read mcu on board 9s12

[borshch]

Read mcu on board 9s12
will try. never had luck reading 9s12 or 908 MCUs with UPA-S programmer (original)..

[lwood]

will try. never had luck reading 9s12 or 908 MCUs with UPA-S programmer (original)..

really. very easy with upa's original. post picture of pinouts. i think something wrong.

[borshch]

i was desoldering MCU and put it in the adapter. UPA keeps scanning thru "set baud rate" and doesnt read it..

[clusters]

:eek: Just use the BDM pads on the cluster, way easier. lol

[epd1221]

Take a pic and we can point out pads easy job with upa .. No need to desolder

[lwood]

i was desoldering MCU and put it in the adapter. UPA keeps scanning thru "set baud rate" and doesnt read it..

WoW. dont remove. just use BDM pins. in back.

[borshch]

WoW. dont remove. just use BDM pins. in back.

ok ill try that. will try to find the pinout here on forum.
but i dont know why UPA does that, maybe i set setting wrong in upa or something.
what exact setting should i set to read this mcu in upa ?

[lwood]

ok ill try that. will try to find the pinout here on forum.
but i dont know why UPA does that, maybe i set setting wrong in upa or something.
what exact setting should i set to read this mcu in upa ?


dont change any setting. only if you want to read flash memory.

[chichu79]

Read with carprog BDM 568657568658