View Full Version : ML 320 w164 Airmatic Calibration problem
Vsmart
16th March, 2019, 11:43 AM
Hello ,
i have problem of calibrating suspension levels after getting strut error and changing
suspension .
now i have Calibration no successfuly carried out .
i have tried to input many values i got on the internet but to no
avail .
can someone help me do this calibration
i am using star and maxisys elite
i need correct values to help me finish this job
thanks in advance
ollync
16th March, 2019, 12:11 PM
The level adjustments are meant to be performed with the car on a chassis alignment system and the inclination angles, as measured by a Romess CM-09606 inclination measuring instrument, entered into SDS just prior to saving the final values.
Not just enter some random values , if you want to do it properly.
Sent from my iPhone using Tapatalk Pro
hesham10
16th March, 2019, 12:28 PM
select actuation .. level valves .. automatic height adjustment .. be sure that no fault codes first
Vsmart
16th March, 2019, 12:37 PM
I HAVE ERROR CODE 5502 which cannot be cleared
but says calibration not carried out successfuly
hesham10
16th March, 2019, 12:57 PM
I HAVE ERROR CODE 5502 which cannot be cleared
but says calibration not carried out successfuly
Ok try what on previous post if you can't ,, try on actual values level sensors on mm ,, check for logical heights for all wheels ,, may be one of them not properly installed so may see wrong height with no fault code .. and report
brend
16th March, 2019, 01:28 PM
For this job better if you have Xentry or high price /level good tool.
With low price tool in mersedes-Benz you just f604407k you self forever!!!
ollync
16th March, 2019, 04:17 PM
Post picture with reading of actual levels in mm and sensor voltage
Check if sensors are mounted corectly, and not backwards.
Sent from my iPhone using Tapatalk Pro
Vsmart
18th March, 2019, 08:35 AM
Post picture with reading of actual levels in mm and sensor voltage
Check if sensors are mounted corectly, and not backwards.
Sent from my iPhone using Tapatalk Pro
Thanks very much Ollync for your tutorials .
i got into actuation .. level valves .. automatic height adjustment . it automatically adjusted all
the heights . yet the error code could not be erased and the height button on the center of
the console does not work. when i press it its light stays remains on and nothing happens .
i will check on the sensor voltage to see if i could figure out something .
Thanks very much for all the assistance
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.