Mazda 2015 BRE7-57K30 XC2336A-56F80L Pinout

[henal]

Hi guys,

anyone have tested pinout for this board,

i've tried the carprotool one and its my power supply is tripping when i feed 12v

i'm currently trying to read it with SMOK, but SMOK has no diagrams and their support of dog shit.

Kind Regards

[PSAcars]

Hello to all. Yes pinout is correct. You will have 0.7A for 1s and then it will be 0.2-0.3A normal current. Can you connect to ecu in car, if yes- power and read, if no- problem with airbag ecu power chip.

[henal]

Ok, will test since i always keep current low (200-400) when testing pinouts

[henal]

Hi,

ok ive tested it, yes the current is over 700mA and then after 3 secons falls to 200mA which is normal,

im trying to read with SMOK but im getting
Read XC23xxA-56F (JTAG) 64kB
Licence Accepted
Vout=5.11V
ID: 0000FFFF
Wrong Conection !!!
Read Error
Read Status Error !!!


is there any solution ? ive done all connection correct and checked again and again ?

anyone had success with SMOK reading this ? or is it JUNK tool ?

[PSAcars]

Hello to all. The wires that you use to short pins on picture MUST be as short as possible.

[henal]

Hi,

shortest possible ive even tested connectivity, im honestly trying everything,

ive attached pictures of my connection everything looks good.

any advice ?

[PSAcars]

Hello to all. On your pictures I dont see pin TMS connected. How long is the wires from programmer to ecu

[henal]

Hello to all. On your pictures I dont see pin TMS connected. How long is the wires from programmer to ecu


spot on, must have come out after i was pulling hairs checking all connecting and worried for tripping power supply, connect it and now all reading, feel more happy thank you my friend.

i've attached in out diagram for SMOK users all tested,

since developer is dead or something as no reply or help for this tool.

[henal]

Whats the best way to clear ? got two of these to do. manually or application ? can't find this in airbag service tool

Kind Regards