View Full Version : 2019 Odyssey
highrisk
16th May, 2020, 06:37 PM
Has anyone done one? Need a little help if possible.. I have Jprog Smelecom and Stool . Jprog don’t give an option by OBD and don’t see it in the file option. Smelecom does not have the option for the 93c86 chip. And stool will wire up and read it but will not write Back to certain section it says write protected.. so if I remove the chip and read it with Smelecom can I use something comparable like CRV has an c86 715151
715152
715153
Sent from my iPhone using Tapatalk
jomberykaso
16th May, 2020, 06:42 PM
just read 93c86 and post your file here
highrisk
16th May, 2020, 07:47 PM
this is the file from STool on board
jomberykaso
16th May, 2020, 07:56 PM
very easy Denso algorithm, the same used in Toyota Yaris 93c56
highrisk
16th May, 2020, 08:25 PM
Can you adjust to 4000 or should I remove from board or leave on board to write to
Sent from my iPhone using Tapatalk
jomberykaso
16th May, 2020, 08:32 PM
always remove eeprom to read and to write
highrisk
16th May, 2020, 08:38 PM
i will post back...and Thank You..for your help
highrisk
16th May, 2020, 10:41 PM
Perfect Thank You again
Sent from my iPhone using Tapatalk
jomberykaso
16th May, 2020, 10:51 PM
Your welcome
digimile
17th May, 2020, 02:13 PM
hi
if stool wont write ...then need to read full flash and send to stool they add the firmware...
thanks
highrisk
17th May, 2020, 05:57 PM
I did yesterday
Sent from my iPhone using Tapatalk
MECANPRO0499
14th October, 2020, 02:00 PM
2019 odyssey have eeprom pine out or remove eeprom THANKS
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.