PDA

View Full Version : SID206 Focus 2 1.8TDCI immo resync after Kess


trotyl
26th July, 2021, 11:47 PM
Hello!
After flash new file by Kess immo lamp blinking and not start. I put back in recovery ori file but not effect, immo blinking. I hope is only resync becouse I've communication with PCM, no faults.
DTC about security only in clustrer.

In attachment files from trasdata:

eeprom + flash.

If somebody can help will be great.
ecuprogramer
27th July, 2021, 08:35 AM
hi friend read dasch eeprom and ecu eeprom for sync and upload
danielif
27th July, 2021, 08:41 AM
Disconect batery for 5 minuts
trotyl
27th July, 2021, 01:14 PM
Disconect batery for 5 minuts

not working, not this time.

However, problem is solved.

I use ELMconfig, ecu response but not give me VID, I can not read or write VID data and VIN also.
I download calibration file from:
http://civil.iffc.ru/ELMConfig/Calibration%20Files/
and did like this:
I open ori file what was firstly read by kess, elmconfig recognize VID data, next I load to elm config PHF file from website but keep VID data from ori, and I push "write current firmware to PCM". After 93 minutes shity ford start. How possible self sychro, Im not sure. So I'm so good. Thanx for reply!