Opel Movano - Renault Master III no communication with ABS no steering

[HeXeN]

Hi, opel movano (renault master III 2.3dci 2015)
maybe someone had same problem, no power steering and no communication with abs module

ECM (Engine Control Module)
C12187 Multiplexed Traction Control Connection,Invalid Source Computer Multiplex Signals.
050464 Brake Switch Signal Consistency,Plausibility. Active
1525F3 Consistent Multiplex Signals For CC/SL,The Data Supplied To The Cruise Control Or Speed Limiter Are Not Correct.


IC (Instrument Cluster)
940113 Oil Level Sensor Circuit,Open Circuit Memory
94011C Oil Level Sensor Circuit,Feed Voltage Too Low Memory
94021C Fuel Sender Circuit,Feed Voltage Too Low Memory
940417 Battery Voltage,Battery Voltage Too High Memory
94051C Instrument Panel,Feed Voltage Too Low Memory
940D86 Vehicle Speed Multiplexed Information,Signal Incoherence.
C12987 ABS/ESP Multiplex Transmission Absent Active

UCH
C07387 CAN Communication Circuit,No Communication Active
953514 Brake Pad Wear Warning Light,Open Circuit Or Short Circuit To Earth

SRS (Supplemental Inflatable Restraint System)
C12187 ABS/ESP Multiplex Transmission Absent Active
C10087 Injection Multiplexed Emission Missing Memory
C14087 No UCH Multiplex Signal

UPC
923A67 Battery Disconnection,Signal Incorrect. Memory
921515 Front Side Lights,Open Circuit Or Short Circuit To +12 V Active
921415 Rear Left Side Lights,Open Circuit Or Short Circuit To +12 V
926768 Stop And Start Module Circuit,Specific Information Active
926681 Battery Current Sensor,Communication Disrupted Active
927264 Dipped Beam Request.,Implausible Signal Memory
927364 Start Of Clutch Switch Travel Circuit,Implausible Signal Memory
927462 +APC 6 Circuit,Signal Incoherence.

Variable P.A.S
D20087 ABS Multiplexed Information Invalid,Missing Message Active
D00187 Steering Wheel Angle Sensor,Missing Message Active
561068 Inhibited,Specific Information Active

[Meat-Head]

Sounds like abs module dead or. Broken can wire

[HeXeN]

I think this could be Variable P.A.S or UCH software corrupted, client told me it happened after he used some china clone diagnostic tool, and clicked something he doesnt remember what exactly. Then this happened. I dont have CLIP online to make re-prog of this two modules. I sent him to dealer to check.

[Meat-Head]

That was intelligent of him

what did dealer say? $$$$$$$$$$$$$$$$$