land rover sport 2006 dash swapping HOW TO ??

[dave11674]

hi guys

im trying to swap a dash o na range rover sport

one aint working and i have a spare one

when i plug new dash in i get no cranking
so deffo immo in there

ive heard you just cant swap the 35080 from the back of the pcb

does anyone know if the mcu can be read as im sure thats the other chip that needs sorting to get it to work right
coding i mean

thanks

dave


EDIT...

numbers on mcu are
079103540590HIXX
64F2636F20
H8S/2636
UJ 0652
AM96888
R050708

[smartymarti]

Ring me pal

[diagtech]

Start car with old dash in take old one out while still running and put new one in and leave running for a short while done a few this way when changing from kms to miles

[dave11674]

i tried this diagtech

i had 2 sports side by side one dash needles faulty other fine so didnt wanna loose any coding
so started both up
swap dashes
waited about 5 mins with them still running and the one i was sat it i turned off and it wouldnt turn after that
so swapped back and both started up

no coding was swapped by doing it this way ! :S

dave

[smartymarti]

Copy the good dashes EPROM over and do as Matt says

[paulocallaghan]

It doesent work , I tried it few months ago

[diagtech]

I did 2 last month converting from km to miles took cluster out while car running changed fascia and put uk dump in to change display to miles and put back in while running both were fine.

[paulocallaghan]

Glut u kept original cluster in each vehicle and you just changed the dumps ????

[dave11674]

how long does it take to code up once you put dash back in ?

dave

[diagtech]

Just left mine running for about 5 mins mate

[dddrrift]

having to do something similar myself, only my old cluster is toast, literally, small cabin fire made sure of that for me. Iv got a used cluster and have salvaged the old semi-burnt pcb from the old cluster, what do i need to swap or can it be wiped and start again?

To complicate matters the LCM is completely destroyed

any help would be much appreciated as im stumped

[will4u69]

Using JLR SDD program as new clocks and all will work.

Sent from my SM-G930F using Tapatalk

[dddrrift]

bought JLR SDD yesterday but seem to be getting mixed info online that used clusters can or cannot be recoded to work in another car. Do you just program the clocks as new?

[will4u69]

Yes leave your old clocks in then go to program new clocks it tells you to swap clocks and programs them .

Sent from my SM-G930F using Tapatalk

[dddrrift]

ok i will give it a go, although the old cluster pcb is damaged it still illumintes etc so hope it works! Thanks