I want to read MCU 0L02M "MC68HC08AZ48A"
Have Orange5 and connection diagrams shows :
MC68HC08AZxxx (QFP64)
PTA0:26 - Prog. RxD
IRQ:2 - Prog. V10V
RST:3 - Prog. RST
PTC0:60 logic 1
PTC1:61 logic 0
PTC3:63 logic 0
Vss:21 - Prog. GND
OSC1:59
Vdd:22 - Vcc (optional)
Question: where is logic 1;logic 0 pinouts in programmer ?orange-5-ecu-programmer-pinout-1.jpg
Results 1 to 6 of 6
Thread: Orange5 programmer HELP
-
10th December, 2015, 07:10 PM #1DK Veteran
- Join Date
- Oct 2009
- Location
- Garage
- Posts
- 626
- Thanks
- 105
- Thanks
- 308
- Thanked in
- 85 Posts
Orange5 programmer HELP
-
10th December, 2015, 07:57 PM #2Junior Member
- Join Date
- Dec 2014
- Posts
- 39
- Thanks
- 14
- Thanks
- 40
- Thanked in
- 19 Posts
Logic 1 - connected via a resistor 1kOm to Vcc;
Logic 0 - connected to GND.
-
The Following 7 Users Say Thank You to Mihali4 For This Useful Post:
andresvargas704 (2nd May, 2019), barto41 (2nd February, 2020), narkeleptk (31st December, 2018), raimi.s (10th December, 2015), Rotor (31st May, 2023), rrr500 (27th November, 2019), StormBY (14th April, 2024)
-
10th December, 2015, 08:25 PM #3DK Veteran
- Join Date
- Jun 2010
- Location
- digital-kaos
- Posts
- 1,855
- Thanks
- 557
- Thanks
- 1,133
- Thanked in
- 529 Posts
Better is to remove processor and solder to adapter
Actions speak louder than words
-
The Following User Says Thank You to ttzag For This Useful Post:
raimi.s (10th December, 2015)
-
10th December, 2015, 08:42 PM #4DK Veteran
- Join Date
- Oct 2009
- Location
- Garage
- Posts
- 626
- Thanks
- 105
- Thanks
- 308
- Thanked in
- 85 Posts
I dont have adapter but i will do
-
10th December, 2015, 08:49 PM #5DK Veteran
- Join Date
- Oct 2009
- Location
- Garage
- Posts
- 626
- Thanks
- 105
- Thanks
- 308
- Thanked in
- 85 Posts
Any one maybe knows SEC for this mcu ?
-
10th December, 2015, 09:05 PM #6Junior Member
- Join Date
- Dec 2014
- Posts
- 39
- Thanks
- 14
- Thanks
- 40
- Thanked in
- 19 Posts
http://www.digital-kaos.co.uk/forums...-M-clone/page2
Originally Posted by raimi.s
-
The Following User Says Thank You to Mihali4 For This Useful Post:
raimi.s (10th December, 2015)
Reply With Quote
Bookmarks