Why not? Key 1 and 2 are used ...
Why not? Key 1 and 2 are used ...
It will show only if you load dump read by OBD with CGDI. If you read EIS with external programmer and then load dump to CGDI it will not show which positions are used. They should fix it, I reported it like half year ago.
yugo45 (7th September, 2018)
always should gues what position to choose
If we have working key then we can check on what position is it written, then no problem to just choose one of the others to avoid overwriting working key position. If we have lost keys situation then if we want to keep working keys activated then I ask friend to load dump to SKC and he tell me which positions are free
the official website has been down since yesterday.
the password server is still running.
I can open the offical website successfully on my PC.
yes, site is back
hi... which keys can we use with cgdi? xhorse keys or any chinese keys.
TMM (28th August, 2018)
Chinese key work good
canakbas (29th August, 2018)
Just bought one, hopefully this tool and the servers last for a good while. Got a lot to study, hope to not burn up someone's car out there.
What keys will I need to stock to cover the models this tool can do. Does iyz-3312 fob cover pretty much most of 2002 - 2006? What else should be stocked? Trying to figure out what all will be needed on hand.
v2.7.0.0
w211 2005 keyless go
1 key present 59
read eis ok
collect data, choose key, other keys
voltage v13.51
compute pasword,,
insert key eis ok
insert key in cgdi
starting key collection
after a few minutes, message, is the key loose?
press ok
after this message device information failed
sn: unknown
it is like the device is disconnected.
restart program, still getting message device information failed.
disconnect obd, same
disconnect usb restart ok
how can this be, i tried with w7.32 and w7.64
Run admin, no virus scanner
internet connection ok.
voltage 12.5 up to 13.5
even tried with turned on hazard lights.
reinstalled software, then updated to 2.7.0.0
I am now reading it as akl.
Disconnected elv, connected k-line
This works, takes about 40min of data reading.
Last edited by rob h; 29th August, 2018 at 02:47 PM.
.v2.7.0.0
w211 2005 keyless go
1 key present 59
read eis ok
collect data, choose key, other keys
voltage v13.51
compute pasword,,
insert key eis ok
insert key in cgdi
starting key collection
after a few minutes, message, is the key loose?
press ok
after this message device information failed
sn: unknown
it is like the device is disconnected.
restart program, still getting message device information failed.
disconnect obd, same
disconnect usb restart ok
how can this be, i tried with w7.32 and w7.64
Run admin, no virus scanner
internet connection ok.
voltage 12.5 up to 13.5
even tried with turned on hazard lights.
reinstalled software, then updated to 2.7.0.0
I am now reading it as akl.
Disconnected elv, connected k-line
This works, takes about 40min of data reading
I read w221 2008 and Car with Keyless GO and all was fine with collect Data on Car with OBD.
But at this moment is useless, CGDI can erase NEC from Keyless GO Key but dont write!
Have 2 Keyless GO Keys here erased but cant write and this moment cant sell too!
Hi can cgdi eis/esl virgin with this tool
Plz information on it thanks
yes, but i think not all
Ok can you information what years of car it use and do good job
Bookmarks