Hi guys I'm hoping someone can help me I purchased a digiprog3 off Amazon brand new with the 40 cables and basically I removed my 2004 BMW 530i cluster opened it up to get to the eeprom I attached the st01 cable to the epprom while it was on the circuit board changed the mileage but once I plugged back in the cluster to the BMW the cluster went into cluster test mode where all the dials and stuff move back and forth etc it stays in that mode for hours but once I turn the ignition key over to start position the cluster comes on..... Then I got all the malfunctions warnings like speedometer malfunction dynamic body malfunction tpm malfunction. Cruise control malfunction etc.... When I off the car and turn it back on the cluster works for 10 seconds then the rpm needle, fuel gauge, and the litres per 100kms guage go dead but the speedometer still works which shows how fast I'm going..... Also my fuel range is affected I filled the tank up but the fuel range only went up Abit I tried connecting to cas3 model it search's for about a minute than says unkown version..
Any help would be greatly appreciated
The mileage did change to the amount I set it at but now there's the red tamper dot along with the issues and malfunctions etc.... My main concern is the fuel range and fuel gauge as I don't know how much I have.... But I really wanna fix all those malfunctions and erase them.... What do I need to do?
Bookmarks