Fiat 500 2016 Key Programming

[DiagExpert]

Hello to all DK experts,

I'm trying to program a new remote key for this Fiat 500 with Delphi BSI i have read the precoding data from NEC 70F3633 with IO Terminal from P1 to P6 and precode them with Hitag 2, then i'm trying to program it with Multiecuscan the car starts fine but the remote does not work.
Can anyone tell me if the precoding data are correct i attach the files and the data readed from BSI.

Regards

[pepi]

Check remote compatibility .If car starts ok you have done properly precoding.

[dtip]

Check remote compatibility .If car starts ok you have done properly precoding.

not necessarily on fiat, if remote pages are not correctly precoded car will start but remote wont work

[DiagExpert]

problem solved, the pages must be precoded with the right order otherwise the remote will never work.

Regards

[ASCM]

problem solved, the pages must be precoded with the right order otherwise the remote will never work.

Regards

Which tool u used to precode all pages in emulated transponder

Sent from my 5033F using Tapatalk

[lion0304]

Which tool u used to precode all pages in emulated transponder

Sent from my 5033F using Tapatalk

ANy hitag2 can do if you have right data. Do it by hand.

[DiagExpert]

Which tool u used to precode all pages in emulated transponder

Sent from my 5033F using Tapatalk

i have done it manually with VVDI Key Tool.

[rokibar]

But you locked key when programmed. Impossible change anything in locked chip.

[DiagExpert]

But you locked key when programmed. Impossible change anything in locked chip.

i used Xhorse universal remote with XT27 chip inside so these are rewritable.

[ASCM]

i used Xhorse universal remote with XT27 chip inside so these are rewritable.

Did you readed ori pages from and old flip key or anything else for writing correctly pages in remote xt27

Sent from my 5033F using Tapatalk

[DiagExpert]

Did you readed ori pages from and old flip key or anything else for writing correctly pages in remote xt27

Sent from my 5033F using Tapatalk

it is not possible to read the ori flip key because is locked, i readed with IO Terminal OBD with Fiat BSI2 license.

[rokibar]

it is not possible to read the ori flip key because is locked, i readed with IO Terminal OBD with Fiat BSI2 license.

Are data visible?

[DiagExpert]

Are data visible?

of course are visible, i have attached photo in the first post.

[Alpaholic]

problem solved, the pages must be precoded with the right order otherwise the remote will never work.

Regards

What kind of order? 10/16 pin or 8 pin ?

[DiagExpert]

the order is like this: page 4-5-6-1-2-3, 10/16 pin.